Spring navigationen over
    • Raspberry Pi 7" touchscreen case with Lego studs

    Raspberry Pi 7" touchscreen case with Lego studs

    Dette produkt er endnu ikke blevet bedømt.0
    Computer & KontorComputereSingle-board computer (SBC)

    Raspberry Pi 7" touchscreen case with Lego studs

    Varenummer: RASPI3CABLTOU
    Dette produkt er endnu ikke blevet bedømt.0
    SmartiPi

    Kort om produktet

    With this touchscreen case for Raspberry Pi, you can fit the micro computer, 7-inch touchscreen and camera module into a handy enclosure that can be wallmounted, adjusted for angle and comes with Lego studs on the front for additional devices.Læs mere om produktet
    229.-183.-
    Ekskl. moms
    Dette produkt er ikke på lager

    Specifikationer

    • Fits Raspberry Pi + 7" touchscreen
    • Lego-compatible camera case
    • Pivoting stand, 75 mm VESA
    Se alle specifikationer

    The touchscreen case for Raspberry Pi allows you to install the micro PC into a closed compartment with easy access to ports. The case also fits the 7-inch touchscreen display which is held in place by four screws. The case has pivoting stand which supports multiple angles of incline and has rubber feet for non-slip placement on smooth surfaces. The included Raspberry Pi camera case uses Lego-compatible studs for installation. There are additional studs on the front for mounting more accessories. The case can be also wallmounted thanks to VESA 75 mm mount points with pre-drilled M4 screw holes.

    Compatibility: Fits Raspberry Pi models A+, B+, 2 and 3

    NB: Raspberry Pi, touchscreen, Raspberry Pi camera and Lego figurine not included - for illustration only.

    Box contents:
    - Raspberry Pi enclosure
    - 4 screws for touchscreen
    - Pivoting stand
    - Micro USB Y-cable for simultaneous power to micro computer and touchscreen
    - Ribbon cable for camera connection
    - Lego-compatible camera case
    - 2 pivoting mounts with screws
    - Hex wrench